Ip Msdp Sa-Filter - Dell S4810 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Usage
Modifications to the ACL do not have an immediate effect on the sa-cache.
Information
To apply the redistribute filter to entries already present in the SA cache, use the
clear ip msdp sa-cache local command.

ip msdp sa-filter

Permit or deny MSDP source active (SA) messages based on multicast source and/or group from the
specified peer.
S4810
Syntax
ip msdp sa-filter {in | out} peer-address list [access-list
name]
Remove this configuration using the no ip msdp sa-filter {in | out}
peer address list [access-list name] command.
Parameters
in
out
peer-address
access-list
name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1110
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the keyword in to enable incoming SA filtering.
Enter the keyword out to enable outgoing SA filtering.
Enter the peer address of the MSDP peer in a dotted decimal
format (A.B.C.D.).
Enter the name of an extended ACL that contains permitted
SAs. If you do not use this option, all local entries are
blocked.
Multicast Source Discovery Protocol (MSDP)