Show Ip Management-Eis-Route; Show Management Application Pkt-Cntr - Dell S4810 Reference Manual

To disable and remove management egress interface selection (EIS) configurations,
use the no management egress-interface-selection command.
Defaults None.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2)

show ip management-eis-route

Display the management routes used by EIS.
S4810
Syntax
show ip management-eis-route
Defaults None.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0)
Example
Dell#show ip management-eis-route
Destination
-----------
10.11.0.0/16
172.16.1.0/24

show management application pkt-cntr

Display the number of packets for each application type that have taken the management route.
S4810
Syntax
show management application pkt-cntr
Defaults None.
800
Introduced on the Z9000, S4810, and S4820T.
Introduced on the Z9000, S4810, and S4820T.
Gateway
-------
ManagementEthernet 0/0
10.11.192.4
State Route Source
----- ------------
Connected Connected
Active Static
Interfaces