Radius-Server Retransmit - Dell S4810 Reference Manual

If you configure the key parameter in the radius-server host command, the
key configured with the radius-server key command is the default key for all
RADIUS communications.
Related radius-server host
Commands

radius-server retransmit

Configure the number of times the switch attempts to connect with the configured RADIUS host server
before declaring the RADIUS host server unreachable.
S4810
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3
command.
Parameters
retries
Defaults 3 retries
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Related radius-server host
Commands
1478
— configures a RADIUS host.
Enter a number of attempts that FTOS tries to locate a
RADIUS server. The range is from zero (0) to 100. The default
is 3 retries.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a RADIUS host.
Security