Dell S4810 Reference Manual page 1519

ssh
Open an SSH connection specifying the hostname, username, encryption cipher, HMAC algorithm, port
number, and version of the SSH client.
S4810
Syntax
ssh [vrf vrf-name] {hostname | ipv4 address | ipv6 address} [-c
encryption cipher | -l username | -m HMAC algorithm | -p port-
number | -v {1 | 2}]
Parameters
vrf vrf-name
hostname
vrf instance
ipv4 address
ipv6-address
prefix-length
-c encryption
cipher
Security
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
(OPTIONAL) Enter the keyword vrf aand then the name of
the VRF to specify the VRF used with the SSH session.
NOTE: The VRF configured using this command has a
higher precedence than the VRF configured using the ip
ssh vrf vrf-name command. If you do not configure
a VRF using this command, then the SSH client uses the
configured VRF (if any). If there is a mismatch between
VRFs that are configured using the ip ssh source-
interface command and the ssh vrf vrf-name
command, then an error is reported.
(OPTIONAL) Enter the IP address or the host name of the
remote device.
(OPTIONAL) E-Series Only: Enter the keyword vrf then the
VRF Instance name to open an SSH connection to that
instance.
(OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enable the "FIPS mode enable", this mode will support only
v2 client.
"no fips mode enable"(disable) will support v1 & v2 client.
This comment is applicable for both ciphers & HMAC
algorithms:
• 3des-cbc: Force ssh to use 3des-cbc encryption cipher.
• aes128-cbc : Force ssh to use aes128-cbc encryption
cipher
1519