Tc-Flush-Standard - Dell S4810 Reference Manual

tc-flush-standard

Enable the MAC address flushing after receiving every topology change notification.
S4810
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
Usage By default, Dell Networking OS implements an optimized flush mechanism for
Information PVST+. This implementation helps in flushing the MAC addresses only when
necessary (and less often) allowing for faster convergence during topology
changes. However, if a standards-based flush mechanism is needed, you can turn
this knob command on to enable flushing MAC addresses after receiving every
topology change notification.
vlan bridge-priority
Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
S4810
Syntax
vlan vlan-range bridge-priority value
To return to the default value, use the no vlan bridge-priority command.
1322
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
Per-VLAN Spanning Tree Plus (PVST+)