Ip Address - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:
Table of Contents

Advertisement

Usage
To stop packets from flooding the user terminal when debugging is turned on, use
Information
the count option.
The access-group option supports only the equal to (eq) operator in TCP ACL
rules. Port operators not equal to (neq), greater than (gt), less than (lt), or range
are not supported in access-group option (refer to the following example). ARP
packets (arp) and Ether-type (ether-type) are also not supported in the access-
group option. The entire rule is skipped to compose the filter.
The access-group option pertains to:
In the case of ambiguous access control list rules, the debug ip packet
access-control command is disabled. A message appears identifying the error
(refer to the Example below).
Example (Error
Dell#debug ip packet access-group test
Messages)
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is
turned off
Dell#

ip address

Assign a primary and secondary IP address to the interface.
S4810
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the no ip address [ip-
address] command.
Parameters
ip-address
mask
848
IP protocol number: from 0 to 255
Internet control message protocol (icmp) but not the ICMP message type (from
0 to 255)
Any internet protocol (ip)
Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits
User Datagram Protocol (udp)
Enter an IP address in dotted decimal format.
Enter the mask of the IP address in slash prefix format (for
example, /24).
IPv4 Routing

Advertisement

Table of Contents
loading

Table of Contents