Show Ipv6 Cam Stack-Unit - Dell S4810 Reference Manual

Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.4.2.1
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
Usage Because this command is enabled by default, it does not appear in the running
Information configuration. When you disable unicast routing, the no ipv6 unicast-routing
command is included in the running configuration. Whenever unicast routing is
disabled or re-enabled, Dell Networking OS generates a syslog message indicating
the action.
Disabling unicast routing on an E-Series chassis causes the following behavior:
•
•
•
•
•

show ipv6 cam stack-unit

Displays the IPv6 CAM entries for the specified stack-unit.
S4810
Syntax
show ipv6 cam stack-unit unit-number port-set {0-1} [summary |
index | ipv6 address]
Parameters
unit-number
port-set
IPv6 Basics
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series TeraScale.
static and protocol learned routes are removed from RTM and from the CAM;
packet forwarding to these routes is terminated
connected routes and resolved neighbors remain in the CAM and new IPv6
neighbors are still discoverable
additional protocol adjacencies (OSPFv3 and BGP4) are brought down and no
new adjacencies are formed
the IPv6 address family configuration (under router bgp) is deleted
IPv6 Multicast traffic continues to flow unhindered
Enter the stack unit's ID number. The range is from 0 to 11.
Enter the keyword Port Set.
931