Debug Isis Snp-Packets - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.2(0.2)

Version 9.0.2.0

Version 6.3.1.0

debug isis snp-packets

To debug IS-IS complete sequence number PDU (CSNP) and partial sequence number PDU (PSNP)

packets, enable debugging on a specific interface and provides diagnostic information.

debug isis snp-packets [interface]

To turn off debugging, use the no debug isis snp-packets [interface]

EXEC Privilege

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking Command Line Reference Guide.

Intermediate System to Intermediate System (IS-IS)

Introduced on the Z9000.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

(OPTIONAL) Identifies the interface type slot/port as one of

the following:

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a VLAN, enter the keyword vlan then a number from