Dell S4810 Reference Manual page 1303

destination
interface
direction {rx | tx
| both}
Defaults none
Command MONITOR SESSION (conf-mon- sess-session-ID)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.0.0
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Port Monitoring
Enter the keyword destination to specify the destination
interface.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keyword port-
channel followed by the port-channel id .
Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface enter the keyword VLAN followed by
a number from 1 to 4094.
• For a port channel interface, enter the keyword port-
channel followed by the port-channel id .
Enter the keyword direction then one of the packet
directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving
packets.
Added support for Source and destination.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
1303