Dell S4810 Reference Manual page 1357

qos-policy
qos-policy-
name
Defaults none
Command CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage There are eight queues per interface on the S6000 and four queues on the S-
Information Series. This command assigns a class map or QoS policy to different queues.
Related
class-map
Commands
service-policy input
service-policy output
set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
S4810
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value
Defaults none
Quality of Service (QoS)
(OPTIONAL) Enter the keywords qos-policy then the QoS
policy name assigned to the queue in text format (16
characters maximum). This specifies the input QoS policy
assigned to the queue under policy-map-input and
output QoS policy under policy-map-output context.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— identifies the class map.
— applies an input policy map to the selected interface.
— applies an output policy map to the selected interface.
(OPTIONAL) Enter the keywords ip-dscp then the IP DSCP
value. The range is from 0 to 63.
1357