Dell S4810 Reference Manual page 1388

interface
connected
isis
ospf
static
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Related ip prefix-list
Commands
1388
(OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the keyword connected to filter only
directly connected routes.
(OPTIONAL) Enter the keyword isis to filter only IS-IS
routes.
(OPTIONAL) Enter the keyword ospf to filter all OSPF routes.
(OPTIONAL) Enter the keyword static to filter manually
configured routes.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enters PREFIX-LIST mode and configures a prefix list.
Routing Information Protocol (RIP)