Ipv6 Basics; Clear Ipv6 Fib - Dell S4810 Reference Manual

IPv6 Basics

IPv6 basic commands are supported on the Dell Networking S4810 platform.
NOTE: For information about the Dell Networking operating software version and platform that
supports IPv6 in each software feature, refer to the IPv6 Addressing chapter of the Dell Networking
OS Configuration Guide.

clear ipv6 fib

Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
S4810
Syntax
clear ipv6 fib linecard slot | stack-unit unit-number
Parameters
slot
unit-number
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.7.0
Version 8.2.1.0
Version 7.8.1.0
Version 7.4.1.0
IPv6 Basics
Enter the slot number to clear the FIB for a linecard.
Enter the stack member number.
The range is from 0 to 11 for the S4810.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
29
917