Trust - Dell S4810 Reference Manual

Defaults none
Command CONFIGURATION (config-wred)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.8.0
pre-Version
6.1.1.1
Usage To configure the minimum and maximum threshold values for user-defined
Information profiles, use this command. Additionally, to modify the minimum and maximum
threshold values for the pre-defined WRED profiles, use this command. If you
delete the threshold values of the pre-defined WRED profiles, the profiles revert to
their original default values.
Pre-Defined WRED
Profile Name
wred_drop
wred_ten_y
wred_ten_g
wred_fortyg_y
wred_fortyg_g
Related wred-profile
Commands

trust

Specify dynamic classification (DSCP) or dot1p to trust.
S4810
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
Parameters
diffserv
dot1p
Quality of Service (QoS)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Minimum
Threshold
0
467
467
467
467
— creates a WRED profile.
Enter the keyword diffserv to specify trust of DSCP
markings.
Enter the keyword dot1p to specify trust dot1p
configuration.
Maximum
Threshold
100
0
4671 100
4671 50
4671 50
4671 25
1369