Fefd Reset - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

Version 8.3.7.0

fefd reset

Reset all interfaces or a single interface that was in "error-disabled" mode.

fefd reset [interface]

(OPTIONAL) Enter the keyword normal to change the link

state to "unknown" when a far-end failure the software

detects on that interface. When the interface is placed in

"unknown" state, the software brings down the line protocol.

(OPTIONAL) Enter the keyword aggressive to change the

link state to "error-disabled" when a far-end failure the

software detects on that interface. When an interface is

placed in "error-disabled" state, enter the fefd reset

command to reset the interface state.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

— enables far-end failure detection.

(OPTIONAL) Enter the following keywords and slot/port or

number information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/ port information.