Dell S4810 Reference Manual page 1573

Hide thumbs Also See for S4810:

Table of Contents

The IP address assigned to the management interface is the default.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.2(0.0)

Version 8.3.11.1

Version 8.3.7.0

Version 8.5.1.0

Version 7.6.1.0

Version 7.5.1.0

E-Series legacy

To enable this snmp-server trap-source command, configure an IP address

on the interface and enable the interface configured as an SNMP trap source.

snmp-server community

Simple Network Management Protocol (SNMP) and Syslog

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the S6000.

Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

— sets the community string.