Policy Action Port-Disable - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action port-disable

Administratively disables the source port of the traffic to which this action is applied.
policy action action_name port-disable
policy action action_name no port-disable
Syntax Definitions
action_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove port-disable from the policy action.
•
An SNMP trap is sent when a port is administratively disabled through a port disable action or a User-
Ports shutdown function.
•
To enable a port disabled by this action, use the
tively enable the port, or physically disconnect and reconnect the port cable.
Examples
-> policy action pd01 port-disable
-> policy action pb02 no port-disable
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
interfaces
clear violation ????
OmniSwitch CLI Reference Guide
The name of the action.
interfaces
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
Administratively enables or disables a port.
Administratively clears the violation that disabled the port or link aggre-
gate and restores the port to enabled status.
March 2011
policy action port-disable
or clear violation command to administra-
page 26-143