Ethernet-Service Svlan - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ethernet-service svlan

ethernet-service svlan
Creates a VLAN Stacking VLAN (SVLAN) for tunneling customer traffic.
ethernet-service svlan {svlan_id [-svlan_id2]} [admin-state {enable | disable}] [stp {enable | disable}]
[name description]
no ethernet-service svlan {svlan_id [-svlan_id2]}
Syntax Definitions
svlan
svlan_id
[-svlan_id2]
enable
disable
stp enable
stp disable
description
Defaults
By default, the Spanning Tree status is enabled in both the per-vlan and flat mode when the SVLAN is
created
parameter
enable | disable
stp enable | disable
description
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete an SVLAN or a range of SVLANs. Note that SVLAN port
associations are also removed when the SVLAN is deleted.
•
This command does not work if the svlan_id specified already exists as a standard VLAN.
page 34-2
Creates an SVLAN for tunneling customer traffic.
The VLAN ID number identifying the SVLAN.
The last VLAN ID number in a range of SVLANs that you want to
configure (for example 10-12 specifies VLANs 10, 11, and 12).
Enables the SVLAN administrative status.
Disables the SVLAN administrative status, which blocks all ports bound
to that SVLAN.
Enables the SVLAN Spanning Tree status for the service provider
network topology.
Disables the SVLAN Spanning Tree status for the service provider
network topology.
An alphanumeric string. Use quotes around the string if the VLAN
name contains multiple words with spaces between them (for example,
"Alcatel-Lucent Engineering").
default
enable
enable
VLAN ID number
VLAN Stacking Commands
OmniSwitch CLI Reference Guide March 2011