Ipv6 Multicast Last-Member-Query-Interval - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast last-member-query-interval

ipv6 multicast last-member-query-interval
Sets the MLD last member query interval on the specified VLAN or on the system if no VLAN is speci-
fied.
ipv6 multicast [vlan vid] last-member-query-interval [milliseconds]
Syntax Definitions
vid
milliseconds
Defaults
parameter
milliseconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
IPv6 Multicast Switching and Routing must be enabled to set the MLD last member query interval to
use on the system and/or the specified VLANs. apply this configuration.
•
If the MLD last member query interval is already configured on the system, then the VLAN configura-
tion will override the system's configuration.
•
The MLD last member query interval refers to the time period to reply to an MLD query message sent
in response to a leave group message.
•
To restore the MLD last member query interval to its default (i.e., 1000 milliseconds) value on the
system if no VLAN is specified, use ipv6 multicast last-member-query-interval followed by the
value 0 (e.g., ipv6 multicast last-member-query-interval 0) or use only
ipv6 multicast last-member-query-interval (e.g., ipv6 multicast last-member-query-interval).
•
To restore the MLD last member query interval to its default (i.e., 1000 milliseconds) value on the
specified VLAN, use ipv6 multicast vlan vid last-member-query interval followed by the value 0
(e.g., ipv6 multicast vlan 2 last-member-query-interval 0) or use only
ipv6 multicast vlan vid last-member-query-interval (e.g., ipv6 multicast vlan 2 last-member-query-
interval).
Examples
-> ipv6 multicast last-member-query-interval 2200
-> ipv6 multicast last-member-query-interval 0
-> ipv6 multicast last-member-query-interval
-> ipv6 multicast vlan 4 last-member-query-interval 2200
-> ipv6 multicast vlan 4 last-member-query-interval 0
-> ipv6 multicast vlan 4 last-member-query-interval
page 21-64
VLAN on which to apply the configuration.
MLD last member query interval in milliseconds. Valid range is 1 to
65535.
default
1000
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011