Policy Condition Destination Ip - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy condition destination ip

Configures a destination IP address for a policy condition.
policy condition condition_name destination ip ip_address [mask netmask]
policy condition condition_name no destination ip
Syntax Definitions
condition_name
ip_address
netmask
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If a mask is not specified, the IP address is assumed to be a host address.
•
A destination IP address and a destination IP network group cannot be specified in the same condition.
•
Use the no form of the command to remove a destination IP address from a condition; however, at
least one classification parameter must be associated with a condition.
Examples
-> policy condition cond4 destination ip 208.192.21.0 mask 255.255.255.0
Release History
Release 7.1.1; command was introduced.
Related Commands
policy condition
qos apply
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The destination IP address of the Layer 3 flow.
The mask for the destination IP address.
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about a particular policy condition configured on the
switch.
March 2011
policy condition destination ip
page 26-41