Policy Condition Ethertype - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy condition ethertype

Configures an ethertype value to use for traffic classification.
policy condition condition_name ethertype etype
policy condition condition_name no ethertype
Syntax Definitions
condition_name
etype
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove an ethertype value from a condition; however, at least one
classification parameter must be associated with a condition.
•
Enter a numeric or equivalent hex value for the etype.
Examples
-> policy condition cond12 ethertype 8137
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy condition
show policy condition
OmniSwitch CLI Reference Guide
The name of the condition.
The ethertype value, in the range 1536–65535 or 0x600–0xffff hex.
Applies configured QoS and policy settings to the current configuration.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
March 2011
policy condition ethertype
page 26-65