Ipv6 Multicast Spoofing - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast spoofing

ipv6 multicast spoofing
Enables or disables MLD spoofing on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] spoofing [{enable | disable}]
no ipv6 multicast [vlan vid] spoofing
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove an MLD spoofing entry on the specified VLAN or on the
system and return to its default behavior.
•
If the MLD spoofing is already enabled on the system, then the VLAN configuration will override the
system's configuration.
•
MLD spoofing refers to replacing a client's MAC and IP address with the system's MAC and IP
address when proxying aggregated MLD group membership information.
•
You can also restore the MLD spoofing to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only ipv6 multicast spoofing (i.e., ipv6 multicast spoofing).
•
You can also restore the MLD spoofing to its default (i.e., disabled) setting on the specified VLAN, by
using only ipv6 multicast vlan vid spoofing (i.e., ipv6 multicast vlan 2 spoofing).
Examples
-> ipv6 multicast spoofing enable
-> ipv6 multicast spoofing disable
-> ipv6 multicast spoofing
-> ipv6 multicast vlan 2 spoofing enable
-> ipv6 multicast vlan 2 spoofing disable
-> ipv6 multicast vlan 2 spoofing
-> no ipv6 multicast vlan 2 spoofing
page 21-78
VLAN on which to apply the configuration.
Enable MLD spoofing.
Disable MLD spoofing.
defaults
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011