Policy Condition Tos - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

policy condition tos

policy condition tos
Configures the precedence bits in the Type of Service (ToS) byte value for a policy condition.
policy condition condition_name tos tos_value [mask tos_mask]
policy condition conditioning no tos
Syntax Definitions
conditioning
tos_value
tos_mask
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a ToS value from a condition; however, at least one classi-
fication parameter must be associated with a condition.
•
If a ToS value is specified, a DSCP value may not be specified.
Examples
-> policy condition cond2 tos 7
Release History
Release 7.1.1; command was introduced.
Related Commands
policy condition
qos apply
show policy condition
page 26-86
The name of the condition. May be an existing condition name or a new
condition.
The Type of Service bits value included in the IP header. The three most
significant bits of the byte determine the precedence (i.e, priority) of the
frame (0 is the lowest, 7 is the highest).
The mask for the ToS bits, in the range 0–7.
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011