Ip Dvmrp Route-Timeout - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip dvmrp route-timeout

ip dvmrp route-timeout
Configures the route expiration timeout value. The route expiration timeout value specifies how long the
switch will wait before aging out a route. When the route expiration timeout expires, the route is adver-
tised as being in holddown until either its activity resumes or it is deleted from the route table.
ip dvmrp route-timeout seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
N/A
Examples
-> ip dvmrp route-timeout 140
Release History
Release 7.1.1; command was introduced.
Related Commands
ip dvmrp route-holddown
show ip dvmrp
MIB Objects
alaDvmrpGlobalConfig
alaDvmrpRouteExpirationTimeout
page 22-14
Specifies the timeout value, in seconds (20–4000).
default
140
Configures the time during which DVMRP routes are kept in a hold
down state.
Displays the global DVMRP parameters.
OmniSwitch CLI Reference Guide
DVMRP Commands
March 2011