Policy Action Map - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action map

Configures a mapping group for a policy action.
policy action map {802.1p | tos | dscp} to {802.1p | tos| dscp} using map_group
policy action no map
Syntax Definitions
802.1p
tos
dscp
map_group
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When remapping is configured with this command and a flow matches a policy with this remapping
action, and the 802.1p, ToS, or DSCP setting in the incoming flow is specified by the map group, the
value will be remapped in the outgoing flow according to the map group.
•
If the 802.1p, ToS, or DSCP setting in the incoming flow is not a value specified in the map group, the
switch will do one of two things:
If the remap from and remap to types are the same (802.1p to 802.1p, ToS to ToS, or DSCP to DSCP),
the values in the outgoing flow will be unchanged. If the remap from and remap to types are not the
same (for example: 802.1p to ToS), the switch will determine the outgoing 802.1p and ToS based on
whether or not the port is trusted or untrusted).
•
Use the no form of the command to delete the map group from the configuration.
Examples
-> policy action a1 map 802.1p to 802.1p using mapGroup2
-> policy action a2 map 802.1p to tos using mapGroup3
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
Indicates that an 802.1p value should be mapped.
Indicates that a ToS value should be mapped.
Indicates that a DSCP value should be mapped.
The name of the map group, configured through the
command.
March 2011
policy action map
policy map group
page 26-139