Policy Condition Nh - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

policy condition nh

policy condition nh
Configures an IPv6 next header value as a policy condition. This value is compared to the next header
value in the IPv6 header.
policy condition condition_name nh next_header_value
policy condition condition_name no nh
Syntax Definitions
condition_name
next_header_value
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the no form of the command to remove the next header value as a condition; however, at least one
classification parameter must be associated with a condition.
Examples
-> policy condition cond4 nh 100
-> policy condition cond4 no nh
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
show policy condition
page 26-82
The name of the condition.
The next header value (0–255).
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011