Policy Action Tos - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action tos

Configures a Type of Service (ToS) bits value to be applied to packets in outgoing flows to which the
specified policy applies.
policy action action_name tos tos_value
policy action action_name no tos
Syntax Definitions
action_name
tos_value
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a ToS value from a policy action.
•
Note that specifying both ToS and DSCP in the same action is not allowed.
Examples
-> policy action action3 tos 4
-> policy action action3 no tos
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
OmniSwitch CLI Reference Guide
The name of the action.
The three-bit priority value in the IP header that should be set on outgo-
ing frames in flows that match the specified policy. Values range from 0
(lowest priority) to 7 (highest priority).
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
March 2011
policy action tos
page 26-133