Ipv6 Multicast Static-Querier - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ipv6 multicast static-querier

ipv6 multicast static-querier
Creates a static MLD querier entry on a specified port on a specified VLAN.
ipv6 multicast static-querier vlan vid port slot/port
no ipv6 multicast static-querier vlan vid port slot/port
Syntax Definitions
vid
slot/port
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove an MLD static querier entry on a specified port on a speci-
fied VLAN.
•
The ipv6 multicast static-querier command allows you to create an MLD static querier entry on a
specified port on a specified VLAN. This, in turn, enables that network segment to receive all MLD
traffic.
•
You can also create an MLD static querier entry on a link aggregate port by entering
ipv6 multicast static-querier vlan vid port, followed by the link aggregation group number
(e.g., ipv6 multicast static-querier vlan 2 port 7).
Examples
-> ipv6 multicast static-querier vlan 4 port 1/1
-> no ipv6 multicast static-querier vlan 4 port 1/1
-> ipv6 multicast static-querier vlan 4 port 7
-> no ipv6 multicast static-querier vlan 4 port 7
Release History
Release 7.1.1; command was introduced.
page 21-58
VLAN to include as a static MLD querier.
The slot/port number you want to configure as a static MLD querier.
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide March 2011