Policy Action 802.1P - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

QoS Policy Commands

policy action 802.1p

Configures a value to be set in the 802.1p bits of the 802.1Q byte of an outgoing frame for traffic that
matches a policy with this action.
policy action action_name 802.1p 802.1p_value
policy action action_name no 802.1p
Syntax Definitions
action_name
802.1p_value
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove an 802.1p value from a policy action.
•
Note that specifying both ToS and DSCP in the same action is not allowed.
Examples
-> policy action action4 802.1p 7
-> policy action action4 no 802.1p
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy action
show policy action
OmniSwitch CLI Reference Guide
The name of the action.
The priority value to be set in 802.1Q frames. Values range from 0
(lowest priority) to 7 (highest priority).
Applies configured QoS and policy settings to the current configuration.
Creates a policy action.
Displays information about policy actions.
March 2011
policy action 802.1p
page 26-135