Show Port-Security Learning-Window - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

Learned Port Security Commands

show port-security learning-window

Displays the amount of time during which source learning can occur on all LPS ports.
show port-security learning-window
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The source learning time limit is a switch-wide parameter that applies to all ports that have LPS
enabled.
•
If the shutdown time is set to zero, then a source learning time limit is not active on LPS ports.
Note. Source learning of configured authorized MAC addresses is allowed even after the LPS time limit
has expired. However, all learning is stopped if the number of MAC addresses learned meets or exceeds
the maximum number of addresses allowed, even if the LPS time limit has not expired.
Examples
-> show port-security learning-window
LPS Shutdown Config
Convert-to-static
Remaining Learning Window
output definitions
LPS Shutdown Config
Convert-to-static
Remaining Learning Window The remaining amount of time during which the LPS port can learn
Release History
Release 7.1.1; command introduced.
OmniSwitch CLI Reference Guide
= 2 min
= DISABLE
= 110 sec
The configured amount of time during which the LPS port can learn
new MAC addresses.
Indicates whether or not dynamic MACs are converted to static MACs
(enabled or disabled). Configured through the
port-security learning-window
MAC addresses.
March 2011
show port-security learning-window
command.
page 30-19