Ntp Broadcast - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ntp broadcast

ntp broadcast
Enables NTP to broadcast synchronized information to all the clients in the subnet in the configured inter-
val.
ntp broadcast {broadcast-addr} [version version] [minpoll poll interval]
no ntp broadcast {broadcast-addr}
Syntax Definitions
broadcast-addr
version
poll interval
Defaults
Parameter
version
poll interval
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use this command to configure NTP to act in broadcast server mode.
•
Use the no form of this command to remove the configured broadcast servers.This also disables NTP
synchronization information being sent for that broadcast subset.
•
The NTP broadcast address needs to defined to enable NTP broadcast mode. A maximum of 3 broad-
cast addresses can be configured.
•
Use the version keyword to set the correct version of NTP.
•
Use the minpoll keyword to set the minimum poll time for the server. This number is determined by
raising 2 to the power of the number entered.
Examples
-> ntp broadcast 10.145.59.255 version 4 minpoll 5
-> no ntp broadcast 10.145.59.255
Release History
Release 7.1.1; command was introduced.
page 40-18
Subnet for which broadcast updates are regularly sent.
NTP version on which the broadcast updates are sent out on the subnet
for the clients. Value is 3 or 4.
Polling interval for NTP broadcast message. This value is measured in
seconds.
Default
4
6
Network Time Protocol Commands
OmniSwitch CLI Reference Guide March 2011