Show Ip Pim Group-Map - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

PIM Commands

show ip pim group-map

Displays the PIM group mapping table.
show ip pim group-map [bsr | static-rp | ssm | dense]
Syntax Definitions
N/A
Defaults
If the keywords bsr, static-rp, ssm, or dense are included in the command line, then only the entries that
were created by the specified origin are displayed.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If static RP configuration is being used, this information is obtained from those static RP addresses that
are defined through the
RP set are reachable, they will be added to the group mapping table.
•
If the IP multicast groups are mapped to the mode SSM or DM, then the entries created by local SSM
address range configuration using the
range configuration using the
•
If the bootstrap mechanism is being used, this information is obtained from received Candidate-RP
advertisements (when the local router is the BSR; when the local router is not the BSR, this informa-
tion is obtained from received bootstrap messages).
Examples
-> show ip pim group-map
Origin Group Address/Pref Length
---------+---------------------------+-------------+-----+-----------
BSR 224.0.0.0/4
BSR 224.0.0.0/4
Static 232.0.0.0/8
-> show ip pim group-map bsr
Origin Group Address/Pref Length
---------+---------------------------+-------------+-----+-----------
BSR 224.0.0.0/4
BSR 224.0.0.0/4
-> show ip pim group-map static
Origin Group Address/Pref Length
---------+---------------------------+-------------+-----+-----------
Static 232.0.0.0/8
OmniSwitch CLI Reference Guide
ip pim static-rp command. As long as the RP addresses defined in the static
ip pim ssm group
ip pim dense group
RP Address
172.21.63.11
214.0.0.7
RP Address
172.21.63.11
214.0.0.7
RP Address
March 2011
command and local Dense Mode address
command are displayed.
Mode Precedence
asm 192
asm 192
ssm
Mode Precedence
asm 192
asm 192
Mode Precedence
ssm
show ip pim group-map
page 23-51