ip load dvmrp
ip load dvmrp
Dynamically loads DVMRP to memory.
ip load dvmrp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command must be executed before DVMRP can be configured on the switch. In addition, DVMRP
must be administratively enabled before you can run the protocol on the switch. For more information,
refer to the
ip dvmrp admin-state command on page
Examples
-> ip load dvmrp
Release History
Release 7.1.1; command was introduced.
Related Commands
ip dvmrp admin-state
MIB Objects
alaDrcTmConfig
alaDrcTmIPDvmrpStatus
page 22-2
22-3.
Globally enables or disables DVMRP protocol on the switch.
OmniSwitch CLI Reference Guide
DVMRP Commands
March 2011