Qos Port Default Dscp - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

qos port default dscp

qos port default dscp
Configures the ToS/DSCP value to be inserted in flows ingressing on an untrusted port.
qos port slot/port[-port] default dscp value
Syntax Definitions
slot/port[-port]
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The value configured by this command sets the upper byte (precedence) and therefore configures the
ToS/DSCP value for the port.
•
The default DSCP value is not used if there is a matching QoS policy rule that sets the priority.
•
Note that on the 802.1p bit for tagged packets received on untrusted ports is set with the default 802.1p
value, which is configured using the
however, then the DSCP bit is set with the default DSCP value, which is configured using the
default dscp command.
Examples
-> qos port 3/1 default dscp 63
-> qos port 4/1-8 default dscp 33
Release History
Release 7.1.1; command was introduced.
page 25-42
The slot number and port number of the physical port. Use a hyphen to
specify a range of ports (4/1-8).
The ToS/DSCP value. The range is 0–63.
default
0
qos port default 802.1p command. If the packet is untagged,
OmniSwitch CLI Reference Guide
QoS Commands
qos port
March 2011