Reload From - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

reload from

reload from
Reloads both CMMs from the specified directory. There is no CMM failover during this reboot, causing a
loss of switch functionality during the reboot. All the NIs and the secondary CMM will reload.
reload from image-dir {rollback-timeout minutes | no rollback-timeout} [in [hours:] minutes | at
hour:minute] [redundancy-time minutes]
Syntax Definitions
image-dir
rollback-timeout minutes
no rollback-timeout
in [hours:] minutes
at hour:minute
redundancy-time minutes
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Can be issued from Primary CMM only.
•
This command is used to reload the switch from the specified directory.
•
The image directory reload takes place immediately unless a time frame is set using the in or at
keywords.
•
If a rollback-timeout is set, the switch reboots again after the set number of minutes, from the certified
directory. The reboot can be halted by issuing a cancel order as described in the
page 37-6
The directory that contains the image files to be loaded onto the switch.
Sets a timeout period, in minutes. The switch immediately reboots from
the specified directory. At the end of this time period, the switch
automatically reboots again from the certified directory.
The valid range of rollback timeout minutes is 1–15.
Specifies no timeout to rollback. If the command is issued with this
keyword, then the switch continues to run from the specified
directory until manually rebooted.
Optional syntax. Schedules a reload of the to take effect in the specified
minutes or hours and minutes within the next 24 hours.
Optional syntax. Schedules a reload to take place at the specified time
using a 24-hour clock. If you do not specify the month and day, the
reload takes place at the specified time on the current day provided the
specified time is later than the time when the CLI command is issued. If
the specified time is earlier than the current time, the reload takes place
on the following day.
Specifies the time period in minutes that the switch must run without
failure. If a failure occurs within this time period, the switch will reboot
from the certified directory.
reload all
OmniSwitch CLI Reference Guide
CMM Commands
command.
March 2011