ipv6 multicast admin-state
ipv6 multicast admin-state
Enables or disables IPv6 Multicast Switching and Routing on the specified VLAN or on the system if no
VLAN is specified.
ipv6 multicast [vlan vid] admin-state [{enable | disable}]
Syntax Definitions
vid
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
If an IPv6 multicast routing protocol is already running on the system, this command will override this
configuration and always enable IPv6 Multicast Switching and Routing.
•
If the IPv6 Multicast Switching and Routing is already enabled on the system, then the VLAN configu-
ration will override the system's configuration.
•
You can also restore the MLD querying to its default (i.e., disabled) status on the system if no VLAN is
specified by using this command.
•
You can also restore the MLD querying to its default (i.e., disabled) status on the specified VLAN, by
using this command.
Examples
-> ipv6 multicast admin-state enable
-> ipv6 multicast admin-state disable
-> ipv6 multicast admin-state
-> ipv6 multicast vlan 2 admin-state enable
-> ipv6 multicast vlan 2 admin-state disable
-> ipv6 multicast vlan 2 admin-state
Release History
Release 7.1.1; command was introduced.
page 21-44
VLAN on which to apply the configuration.
Enable IPv6 Multicast Switching and Routing.
Disable IPv6 Multicast Switching and Routing.
default
disable
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide
March 2011