Show Ip Dvmrp Nexthop - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ip dvmrp nexthop

show ip dvmrp nexthop
Displays DVMRP next hop entries. This command is used to show the list of next hops on outgoing inter-
faces to which IP multicast datagrams from particular sources are routed.
show ip dvmrp nexthop [ip_address ip_mask]
Syntax Definitions
ip_address
ip_mask
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
If an IP address and IP mask are not specified, the entire DVMRP Next Hop table is displayed.
Examples
-> show ip dvmrp nexthop 172.22.2.115 255.255.255.0
Src Address/Mask
--------------------+--------------------+-------+----------
172.22.2.115/24 vlan-2
output definitions
Src Address/Mask
Interface Name
Vlan
Hop Type
Release History
Release 7.1.1; command was introduced.
page 22-26
Specifies a source IP address for which DVMRP next hop entries will
be displayed.
Specifies a source IP mask for which DVMRP next hop entries will be
displayed.
Interface Name Vlan
The 32-bit source IP address, along with the mask length, shown in bits.
The source IP address and mask are separated by a slash ( / ).
The name of the interface.
The associated VLAN ID.
The hop type of the associated entry. Options include leaf or branch.
If the next hop VLAN has a DVMRP neighbor attached to it, the hop
type will be displayed as branch.
Hop Type
2 branch
OmniSwitch CLI Reference Guide
DVMRP Commands
March 2011