Policy Rule Defaults; Policy Action Defaults - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring QoS

Policy Rule Defaults

The following are defaults for the
Description
Policy rule enabled or disabled
Determines the order in which
rules are searched
Whether the rule is saved to
flash immediately
Whether messages about flows
that match the rule are logged
How often to check for matching
flow messages
Whether to count bytes or
packets that match the rule.
Whether to send a trap for the
rule.
Whether the rule is saved to the
default list

Policy Action Defaults

The following are defaults for the
Description
Whether the flow matching the
rule must be accepted or denied
Tri-Color Marking (TCM) mode
- committed rate and burst size
- peak rate and burst size
Note that in the current software release, the deny and drop options produce the same effect that is, the
traffic is silently dropped.
Note. There are no defaults for the
OmniSwitch AOS Release 8 Network Configuration Guide
policy rule command:
Keyword
enable | disable
precedence
save
log
log interval
count
trap
default-list
policy action command:
Keyword
disposition
cir cbs
pir pbs
policy condition command.
December 2017
QoS Defaults
Default
enabled
0
yes
no
60 seconds
packets
yes (trap sent only on port disable
action or UserPort shutdown
operation)
yes (all policy rules belong to the
default list unless otherwise
specified at the time the rule is
created)
Default
accept
Single-rate TCM (srTCM) mode
CIR=0, CBS=10K
PIR=0, PBS=10K
page 26-35