Show Ip Pim Groute - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ip pim groute

show ip pim groute
Displays all (*,G) state that the IPv4 PIM has.
show ip pim groute [group_address]
Syntax Definitions
group_address
Defaults
By default, entire (*,G) routing table is displayed. To view more detailed (*,G) state information about a
particular group, specify the group address in the command line.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
When the group_address is specified in the command line, the detailed information displayed also
includes the detailed state of every outgoing interface.
Examples
-> show ip pim groute
Total 1 (*,G)
Group Address
---------------+--------------+-------------------+-----------------+-----------
225.0.0.0
225.0.0.1
-> show ip pim groute 225.0.0.0
(*,225.0.0.0)
UpTime
RP Address
PIM Mode
PIM Mode Origin
Upstream Join State
Upstream Join Timer
Upstream Neighbor
RPF Interface
RPF Next Hop
RPF Route Protocol
RPF Route Address
RPF Route Metric Pref
RPF Route Metric
Interface Specific State:
vlan-4
UpTime
page 23-66
A 32-bit multicast address. If an IP address is not specified, the current
PIM status for all multicast route entries are displayed.
RP Address RPF Interface
212.61.60.8 vlan-30
212.61.60.8 vlan-30
= 00h:01m:49s
= 212.61.60.8,
= ASM,
= BSR,
= Joined,
= 00h:00m:11s,
= 212.61.30.7,
= vlan-30,
= 212.61.30.7,
= OSPF,
= 212.61.60.0/24,
= 110,
= 2,
= 00h:01m:49s,
Upstream Neighbor UpTime
212.61.30.7
212.61.30.7
OmniSwitch CLI Reference Guide
PIM Commands
00h:01m:43s
00h:01m:43s
March 2011