Show Ip Dvmrp Prune - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ip dvmrp prune

show ip dvmrp prune
Displays DVMRP prune entries that have been sent upstream.
show ip dvmrp prune [group_address source_address source_mask]
Syntax Definitions
group_address
source_address
source_mask
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
If a group address, source address, and source mask are not specified, the entire Prune table is displayed.
Examples
-> show ip dvmrp prune
Group Address
-----------------+---------------------+-------------
224.0.0.4
output definitions
Group Address
Source Address/Mask
Expires
Release History
Release 7.1.1; command was introduced.
page 22-28
Specifies a pruned group address.
Specifies a source IP address.
Specifies a source IP mask.
Source Address/Mask
143.209.92.14/24
The 32-bit multicast group address.
The 32-bit source IP address, along with the mask length, shown in bits.
The source IP address and mask are separated by a slash ( / ).
The amount of time remaining before the current prune state expires,
displayed in hours, minutes, and seconds.
Expires
00h:00m:30s
OmniSwitch CLI Reference Guide
DVMRP Commands
March 2011