policy condition source mac group
policy condition source mac group
Associates a source MAC group with a policy condition.
policy condition condition_name source mac group group_name
policy condition condition_name no source mac group
Syntax Definitions
condition_name
group_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove a source MAC group from a condition; however, at least
one classification parameter must be associated with a condition.
•
A source MAC address and a source MAC group cannot be specified in the same condition.
Examples
-> policy condition cond4 source mac group mac_group1
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
policy mac group
policy condition
show policy condition
page 26-94
The name of the condition. May be an existing condition name or a new
condition.
The name of the source MAC group, configured through the
group
command.
Applies configured QoS and policy settings to the current configuration.
Configures a MAC group and its associated MAC addresses.
Creates a policy condition.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide
policy mac
March 2011