Ip Dvmrp Subord-Default - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

DVMRP Commands

ip dvmrp subord-default

Changes the initial default assumption on a neighbor's subordinate or non-subordinate status. When the
status value is true, DVMRP neighbors are assumed to be subordinate and traffic is automatically
forwarded to the neighbor upon initial discovery. When the value is false, traffic is not forwarded to the
neighbor until route reports have been exchanged and the neighbor has explicitly expressed dependency.
ip dvmrp subord-default {true | false}
Syntax Definitions
true
false
Defaults
parameter
true | false
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
However, if neighbors in the DVMRP domain have difficulty handling large initial bursts of traffic, it
is recommended that the neighbor's default status as a suboridinate be changed to false.
•
To view the current subordinate neighbor status, use the
tion, refer to page
Examples
-> ip dvmrp subord-default false
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
DVMRP neighbors are assumed subordinate; traffic is automatically
forwarded to the neighbor on initial discovery.
DVMRP neighbors are not assumed to be subordinate; traffic is not
forwarded until route reports have been exchanged and the neighbor has
explicitly expressed dependency.
default
true
22-19.
March 2011
show ip dvmrp command. For more informa-
ip dvmrp subord-default
page 22-15