Ntp Src-Ip Preferred - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ntp src-ip preferred

ntp src-ip preferred
Configures the source IP address field of the NTP source
ntp src-ip preferred {default | no-loopback0 | ip_address}
no ntp src-ip preferred
Syntax Definitions
default
no-loopback0
ip_address
Defaults
By default, the NTP source ip preferred setting is set to the default parameter.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When configuring a specific IP address, that address must already exist on the switch.
•
Use the no form of this command to clear a specific IP address and change the behavior back to
default.
Examples
-> ntp src-ip preferred 192.168.10.1
-> ntp src-ip preferred no-loopback0
-> ntp src-ip preferred default
Release History
Release 7.1.1; command was introduced
page 40-8
The Loopback0 address, if configured, will be used for the source IP
address field. If no loopback0 is configured, the vlan configured IP
interface on the switch will be used.
The Loopback0 address should not be used for the source IP address
field and the first available IP address on the switch should be used for
this field.It takes the vlan configured IP even if the loopback0 is config-
ured on the switch.
The IP address to be used in the source IP field.
Network Time Protocol Commands
OmniSwitch CLI Reference Guide March 2011