Show Policy Server Rules - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy server rules

show policy server rules
Displays the names of policies originating from a directory server, that have been downloaded to the
switch.
show policy server rules
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command displays information about policies created on directory servers only.
Commands," for information about configuring and displaying policies directly on the switch.
Examples
-> show policy server rules
Num name
---+-------------------+-------+-------------+------------
1 QoSRule1
2 QoSrule2
Fields are defined here:
output definitions
Num
name
prio
scope
status
page 27-12
prio scope
0 Provisioned
0 Provisioned
An index number corresponding to the policy rule.
The name of the policy rule; only rules configured through PolicyView
are displayed in this table.
The priority or preference of the rule. Indicates the order in which rules
can be checked to match to the incoming traffic. If two or more rules
apply to the traffic, the rule with the highest preference is applied.
Preference is determined when the rule is created.
The type of rule. Provisioned is the only type valid for the current
release.
The status of the rule: Active indicates that the rule has been pushed to
is available in the QoS software on the switch and is available to be
applied to the traffic; notInService means the rule can be pushed to the
QoS software in the future but is not available yet (typically because of
a variable validity period); notReady indicates that the rule can never
be pushed to the QoS software because its validity period has expired
or because it has been disabled through SNMP.
Policy Server Commands
Chapter 25, "QoS
status
Active
Active
OmniSwitch CLI Reference Guide March 2011