Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1879

AAA Commands
output definitions
User name
Password expiration
Password allow to be modified
date
Account lockout
Password bad attempts
Read Only for domains
Read/Write for domains
Read Only for families
Read/Write for families
Snmp allowed
Snmp authentication
Snmp encryption
Possible values for command domains and families are listed here:
Domain
domain-admin
domain-system
domain-physical
domain-network
domain-layer2
domain-service
domain-policy
domain-security
OmniSwitch CLI Reference Guide
The user name for this account.
The date and time on which the password will expire. This field only
displays if the password expiration is configured specifically for a user,
or a default password expiration is configured globally on the switch
through the user password-expiration
time are based on the switch's default system date/time or the system
date/time configured through the
mands.)
The earliest date and time on which the user may change the password.
Configured through the
Indicates if the user account is locked out (Yes or No) and how many
minutes remain until the user account is automatically unlocked. If no
remaining time is displayed, the admin user or a user with admin privi-
leges must manually unlock the account. Configured through the
lockout-duration and
The number of failed password login attempts for this user account.
The command domains available with the user's read-only access. See
the table on the next page for a listing of valid domains.
The command domains available with the user's read-write access. See
the table on the next page for a listing of valid domains.
The command families available with the user's read-only access. See
the table on the next page for a listing of valid families.
The command families available with the user's read-write access. See
the table on the next page for a listing of valid families.
Indicates whether or not the user is authorized to use SNMP (YES or
NO). SNMP is allowed for the user account when SNMP authentica-
tion is specified for the account.
The level of SNMP authentication, if any, configured for the user. This
field only displays if the user is authorized to use SNMP.
The level of SNMP encryption, if any, configured for the user. This
field only displays if the user is authorized to use SNMP.
Corresponding Families
file telnet dshell debug
system aip snmp rmon webmgt config
chassis module interface pmm health
ip rip ospf bgp vrrp ip-routing ipx ipmr ipms
vlan bridge stp 802.1q linkagg ip-helper
dns
qos policy slb
session avlan aaa
March 2011
command. (Note that the date/
system date and
user password-min-age
user lockout unlock commands.
show user
system time com-
command.
user
page 28-49