Show Policy Mac Group - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy mac group

show policy mac group
Displays information about pending and applied MAC groups.
show [applied] policy mac group [mac_group]
Syntax Definitions
applied
mac_group
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Information for all policy MAC groups displays unless mac_group is specified.
Examples
-> show policy mac group
Group Name
State
Entries
output definitions
Group Name
State
Entries
Release History
Release 7.1.1; command was introduced.
page 26-158
Indicates that only MAC groups that have been applied should be
displayed.
The name of the MAC group for which you want to display informa-
tion; or a wildcard sequence of characters for displaying information
about MAC groups with similar names. Use an asterisk (*) to indicate a
wildcard character.
: mg1
= new,
= 00:02:9A:44:5E:10 mask 00:00:00:FF:FF:FF,
00:11:01:00:00:01 mask 00:00:00:FF:FF:FF
00:02:9A:44:5E:20
The name of the port group, configured through the policy mac group
command.
This field appears if the group was created or modified but not yet
applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
The MAC addresses associated with the group.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011