Ntp Interface - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ntp interface

ntp interface
Enables or Disables NTP server functionality for an interface.
ntp interface {interface-ip} {enable | disable}
Syntax Definitions
interface-ip
enable
disable
Defaults
By default, NTP server functionality is enabled on all the interfaces.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use this command to enable or disable the incoming NTP request.
•
Disabling the NTP server functionality drops the NTP request on an interface and synchronization
information is not sent out.
Examples
-> ntp interface 10.10.10.1 disable
-> ntp interface 10.10.10.1 enable
Release History
Release 7.1.1; command was introduced.
Related Commands
show ntp status
MIB Objects
alaNtpAccessRestrictedTable
alaNtpAccessRestrictedIpAddress
page 40-16
IP address of an interface on which NTP server functionality is to be
disabled.
Enables NTP server functionality on an interface.
Disables NTP sever functionality on an interface.
Displays current NTP status.
Network Time Protocol Commands
OmniSwitch CLI Reference Guide March 2011