Show Policy Condition - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show policy condition

show policy condition
Displays information about pending and applied policy conditions.
show [applied] policy condition [condition_name]
Syntax Definitions
applied
condition_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Information for all policy conditions displays unless condition_name is specified.
Examples
-> show policy condition
Condition name
Source VLAN
Condition name
State
Source IP
Destination UDP port
-> show applied policy condition
Condition name
Source VLAN
output definitions
Condition Name
State
Policy Condition Parameters
page 26-166
Indicates that only conditions that have been applied should be
displayed.
The name of the condition for which you want to display information; or
a wildcard sequence of characters for displaying information about
conditions with similar names. Use an asterisk (*) to indicate a wildcard
character.
: c1
= 1001
: c2
= new,
= 10.2.2.1,
= 17
: c1
= 1001
The name of the condition, configured through the policy condition
command.
This field appears if the condition was created or modified but not yet
applied to the QoS configuration. When the qos apply command is
issued, this field no longer displays.
Displays the configured policy condition parameters.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011