Policy Condition Flow-Label - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

policy condition flow-label

policy condition flow-label
Configures an IPv6 flow label value as a policy condition. This value is compared to the flow label value
in the IPv6 header.
policy condition condition_name flow-label flow_label_value
policy condition condition_name no flow-label
Syntax Definitions
condition_name
flow_label_value
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the no form of the command to remove the flow label value as a condition; however, at least one clas-
sification parameter must be associated with a condition.
Examples
-> policy condition cond4 flow-label 1500
-> policy condition cond4 no flow-label
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply
show policy condition
page 26-84
The name of the condition.
The flow-label value (0–1048575).
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011