Policy Action Mirror - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

policy action mirror

policy action mirror
Mirrors ingress, egress, or both ingress and egress packets that match a mirroring policy to the specified
port.
policy action action_name [ingress | egress | ingress egress] mirror slot/port
policy action action_name no mirror slot/port
Syntax Definitions
action_name
ingress
egress
ingress egress
slot/port
Defaults
parameter
ingress | egress | ingress egress ingress
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of the command to remove mirror from the policy action.
•
Use this command to configure a mirror-to-port (MTP) action that is used for policy based mirroring.
•
Only one MTP session is supported at any given time. As a result, all mirroring policies should specify
the same MTP port.
•
Policy based mirroring and the port based mirroring feature can run simultaneously on the same switch.
Examples
-> policy action a1 mirror 1/7 (default ingress)
-> policy action a1 ingress mirror 1/7
-> policy action a1 egress mirror 1/7
-> policy action a1 ingress egress mirror 1/7
-> policy action a1 no mirror
Release History
Release 7.1.1; command was introduced.
page 26-150
The name of the action.
Mirrors ingress packets.
Mirrors egress packets.
Mirrors ingress and egress packets.
The slot and port number that will receive the mirrored traffic.
default
QoS Policy Commands
OmniSwitch CLI Reference Guide March 2011