Show Ip Pim Static-Rp - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

PIM Commands

show ip pim static-rp

Displays the PIM Static RP table for the ASM mode, which includes group address/prefix length, the
static Rendezvous Point (RP) address, and the current status of the Static RP configuration (i.e., enabled or
disabled).
show ip pim static-rp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
If the group prefixes configured for two or more rows in this table overlap, the row with the greatest prefix
length value is used for the overlapping range
Examples
-> show ip pim static-rp
Group Address/Pref Length
---------------------------+-------------+-----+--------+----------+--------
224.0.0.0/4
output definitions
Group Address/Pref Length
RP Address
Mode
Override
Precedence
Status
OmniSwitch CLI Reference Guide
RP Address Mode
172.21.63.11 asm
The 32-bit IP address for a multicast group, along with the mask length,
shown in bits. The group IP address and mask are separated by a slash
( / ). To change the current multicast group address and mask, refer to
the ip pim static-rp command on page
A 32-bit IP address of the Rendezvous Point (RP). To change the cur-
rent RP address, refer to the
The PIM mode to be used for groups in this prefix. The possible values
include asm, ssm, or dm.
Specifies this static RP configuration to override the dynamically
learned RP information for the specified group(s).
Specifies the precedence value to be used for this static RP configura-
tion.
Displays whether static RP configuration is currently enabled or dis-
abled. Options include enabled and disabled. To change the current
status, refer to the ip pim static-rp command on page
March 2011
Override Precedence Status
false none
23-13.
ip pim static-rp command on page
show ip pim static-rp
enabled
23-13.
23-13.
page 23-57